Bronco with Wristed Arms, NP435, Custom Roll Bar
Good pics of wristed front suspension arm and an good custom roll bar.
Open in new window: http://www.vintagebronco.com/colobronco/mem/grow/grow1.htm...
A how-to doc on installing a Smitty roll cage. Includes cool custom ideas for added strength.
Open in new window: http://www.wsu.edu:8080/~i6735189/rollcage.htm
Box mod to Clear Front Roll Bar
"The truck pictured above is Todd Zuercher's truck. To allow access to the stock glovebox with a full roll cage
installed, Todd modified the hinge points on the stock box."
Open in new window: http://broncohq.com/~p-nowak/bronco/html/glove_box_mods.ht...
Resoration Project with Custom Bumpers, Roll Bar, Tilt Steering
This is a nice mod and the owner seems to have a good bit of skill with stainless steel and aluminum fabrication.
Open in new window: http://www.geocities.com/MotorCity/Boulevard/4665/JDFABLIF...
The front bumper is 3 1/2 inch tubing, with an integrated push bar put on the bumper. there are two light mounts in the center of the two bars and hte bumper seals up so I can use it as an air tank. The rear bumper is the same as the front 3 1/2 tubing and used horizontal mounts on the frame for strength.
Open in new window: http://venus.spaceports.com/~bearsden/misc.html
All 4 Fun Specials -- Lengthened
Radius Arms, Full Roll Cage
"New to All 4 Fun Offroad is the long travel radius arms. These arms
allow for maximum wheel travel from the front axle. The arms have a
caster alignment built into them allowing us to use stock rubber
bushings and get even more wheel travel. " This page also features a nice looking full cage.
Open in new window: http://www.broncobob.com/