66-77
Bronco Bumper/Tire Carrier 
A good looking tire carrier bumper.
Open in new window: http://www.metalward.com/broncotirecarrier.html
Winch
Mount Front Bumper
The Bronco front winch bumper is constructed from 2"x4"x3/16" wall tube with the same size tube fitting into the frame rails.
Open in new window: http://www.metalward.com/broncowinchbumper.html
1973
Resoration Project with Custom Bumpers, Roll Bar, Tilt Steering
This is a nice mod and the owner seems to have a good bit of skill with stainless steel and aluminum fabrication.
Open in new window: http://www.geocities.com/MotorCity/Boulevard/4665/JDFABLIF...
Body
Armor
The front bumper is 3 1/2 inch tubing, with an integrated push bar put on the bumper. there are two light mounts in the center of the two bars and hte bumper seals up so I can use it as an air tank. The rear bumper is the same as the front 3 1/2 tubing and used horizontal mounts on the frame for strength.
Open in new window: http://venus.spaceports.com/~bearsden/misc.html
